Tampilkan postingan dengan label pressure washer 5 hp. Tampilkan semua postingan
Tampilkan postingan dengan label pressure washer 5 hp. Tampilkan semua postingan

Selasa, 21 Januari 2014

Can I use my pressure washer to remove paint from concrete porch steps?

pressure washer 5 hp on 580.768210 Craftsman 5.5 HP 2000 PSI 2.0 GPM High Pressure Washer
pressure washer 5 hp image



Mick_man


Craftsman 2550 psi pressure washer - 6.5 HP.
Nozzle is adjustable - High Pressure or Low Pressure plus
Stream or Fan.

There are two coats of paint on the concrete.
Latex - Light Brown paint with Green (unknown paint type) underneath.

I have accidentally removed paint on otyher materials but never tried intentionally removing all paint from a concrete surface. Can I do this? Should I use some sort of solvent/cleaner in conjunction with the washer?

Thanks!



Answer
That thing will almost blast anything off,try it most likely it will work,my neighbor just used one around his house and it took of old grass carpet that they use to put on outside steps.So try it you have nothing to lose except your paint lol You can also try a hard wire brush to help the process. By the way 2550 psi is alot so id say you have a good chance at it.

How do I fix my pressure washer?




Jared


I have a briggs and stratton pressure washer 6.5 hp and I put the eingine on a bike runs great but the eingine is missfiring and stalling every time I gas it can someone please help


Answer
The engine has a governor and is designed to run at only one speed. Without knowing what modifications you made to the engine there's no way to say what you might have done wrong.




Powered by Yahoo! Answers

Rabu, 01 Januari 2014

where can i find specs or operating instructions for a gas operated home water pressure washer, with no mfr.?

pressure washer 5 hp on Details about 5.5HP Petrol Pressure Washer 154bar/2200PSI
pressure washer 5 hp image



Kenneth Y


My pressure washer motor is a 3.5 hp Tecumseh 4-cycle motor: model # H35-45696X-B with a DOM: 6074R. The only identifying mark on the pressure washer pump is a circular stamp in the casing showing 7 raised dots out of 12 spaces, with 95 in the middle of the stamp.


Answer
Both Kärcher and Campbell Hausfeld have used Tecumseh engines for their pressure washers. However, the smallest engine I have found for either manufacturer is 4 HP. A manual for Kärcher's pressure washer is at:
http://www.karcher-usa.com/support/downloads/pdfs/usermanuals/9139-1820.pdf
A manual for Campbell Hausfeld's pressure washer is at:
http://www.campbellhausfeld.net/wcsstore/FashionFlow/pdfs/manual01/466900_0207_web.pdf

The circular stamp may be a date code, perhaps the seventh month (July) of 1995. That would be consistent with your having a 3.5 HP engine, which would be considered too small by today's standards.

I took apart my pressure washer pump and gear oil has spilled all over. How do I reassemble?




X-Men


I took apart my Karcher K2400HH pressure washer pump unit from the engine and now gear oil is all over on the ground. I think I took the whole pump unit out and now I need to reassemble it back again. How do I put it back together, where do I fill the oil back in and what type of gear oil should I use? Any help would be appreciated.


Answer
I had the same problem with a Generac Model No 1537 2400PSI washer.!!! This unit has a 5.5 HP Honda engine.
I'm a builder, and one of my customers gave me this pressure washer after he had problems with it. Seems he left it with the gas in it for years and gummed up the carb. He told me his daughter ran it without the water turned on and burned up the pressure pump. He bought a new pump, but had no idea how to replace it. When I removed the old pump, I had a flood of oil on the garage floor. The new pump was a Briggs and Stratton kit #193473GS, and did not have the wet bearings of the original. It bolted right up to the bottom of the engine and works like a charm.. It took a little cleaning with Gum-out to get the engine running, but now it works fine.
I remember that there was a drain plug on the side of the pump shaft housing, but nowhere in the service manual did it tell you what weight oil went in there ,or how much.




Powered by Yahoo! Answers

Kamis, 07 November 2013

Can I use my pressure washer to remove paint from concrete porch steps?

pressure washer 5 hp on Mi-T-M , WP-3000-4MHB Work Pro Pressure Washer - 6.5 HP Honda OHV
pressure washer 5 hp image



Mick_man


Craftsman 2550 psi pressure washer - 6.5 HP.
Nozzle is adjustable - High Pressure or Low Pressure plus
Stream or Fan.

There are two coats of paint on the concrete.
Latex - Light Brown paint with Green (unknown paint type) underneath.

I have accidentally removed paint on otyher materials but never tried intentionally removing all paint from a concrete surface. Can I do this? Should I use some sort of solvent/cleaner in conjunction with the washer?

Thanks!



Answer
That thing will almost blast anything off,try it most likely it will work,my neighbor just used one around his house and it took of old grass carpet that they use to put on outside steps.So try it you have nothing to lose except your paint lol You can also try a hard wire brush to help the process. By the way 2550 psi is alot so id say you have a good chance at it.

How do I fix my pressure washer?




Jared


I have a briggs and stratton pressure washer 6.5 hp and I put the eingine on a bike runs great but the eingine is missfiring and stalling every time I gas it can someone please help


Answer
The engine has a governor and is designed to run at only one speed. Without knowing what modifications you made to the engine there's no way to say what you might have done wrong.




Powered by Yahoo! Answers