pressure washer best image
X-Men
I took apart my Karcher K2400HH pressure washer pump unit from the engine and now gear oil is all over on the ground. I think I took the whole pump unit out and now I need to reassemble it back again. How do I put it back together, where do I fill the oil back in and what type of gear oil should I use? Any help would be appreciated.
Answer
I had the same problem with a Generac Model No 1537 2400PSI washer.!!! This unit has a 5.5 HP Honda engine.
I'm a builder, and one of my customers gave me this pressure washer after he had problems with it. Seems he left it with the gas in it for years and gummed up the carb. He told me his daughter ran it without the water turned on and burned up the pressure pump. He bought a new pump, but had no idea how to replace it. When I removed the old pump, I had a flood of oil on the garage floor. The new pump was a Briggs and Stratton kit #193473GS, and did not have the wet bearings of the original. It bolted right up to the bottom of the engine and works like a charm.. It took a little cleaning with Gum-out to get the engine running, but now it works fine.
I remember that there was a drain plug on the side of the pump shaft housing, but nowhere in the service manual did it tell you what weight oil went in there ,or how much.
I had the same problem with a Generac Model No 1537 2400PSI washer.!!! This unit has a 5.5 HP Honda engine.
I'm a builder, and one of my customers gave me this pressure washer after he had problems with it. Seems he left it with the gas in it for years and gummed up the carb. He told me his daughter ran it without the water turned on and burned up the pressure pump. He bought a new pump, but had no idea how to replace it. When I removed the old pump, I had a flood of oil on the garage floor. The new pump was a Briggs and Stratton kit #193473GS, and did not have the wet bearings of the original. It bolted right up to the bottom of the engine and works like a charm.. It took a little cleaning with Gum-out to get the engine running, but now it works fine.
I remember that there was a drain plug on the side of the pump shaft housing, but nowhere in the service manual did it tell you what weight oil went in there ,or how much.
How can i tell what pressure my pressure washer is at?
N/A
I have a 3800 psi dewalt pressure washer and im wanting to turn it down to about 3000-3300 psi but im not sure to tell what psi im at while turning the pressure down.
If anyone could help me out id appreciate it!
Thanks!
Answer
What you would have to do is connect a pressure gauge between the end of the hose and the gun. Run the pressure washer with the gun's trigger pressed so there's water flow and check the pressure it is shooting water. To adjust it to the pressure you want you can either use the unloader to regulate pressure or adjust the engine's rotation which would also regulate pressure.
If you need a gauge here is the link to a 5000 psi one. There are more on the website in case you think this one is too much.
http://www.roncoshop.com/GAUGE_KIT_5000_PSI_85305001_p/85305001.htm
What you would have to do is connect a pressure gauge between the end of the hose and the gun. Run the pressure washer with the gun's trigger pressed so there's water flow and check the pressure it is shooting water. To adjust it to the pressure you want you can either use the unloader to regulate pressure or adjust the engine's rotation which would also regulate pressure.
If you need a gauge here is the link to a 5000 psi one. There are more on the website in case you think this one is too much.
http://www.roncoshop.com/GAUGE_KIT_5000_PSI_85305001_p/85305001.htm
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar