Sabtu, 23 November 2013

what are the main tips to remember when power washing a house?

pressure washer injuries on cleaning with pressure washerswith pressure washers pressure washer ...
pressure washer injuries image



Ed C





Answer
- Always wear safety goggles to protect your eyes from splashback or accidental direct spray.

- Make sure all windows are closed tightly.

- Turn off the power to light fixtures and electrical outlets at your home's main service panel. Cover them with plastic bags or film secured with duct tape.

- Place drop cloths over plants and shrubs. Move lawn furniture away.

- If it's windy, don't wash.

- Keep the nozzle 10 to 12 inches from the surface, at about a 45-degree angle.

- Use extra caution when cleaning aluminum or steel siding. A power washer can bend sections - even blow them right off the house.

- Windows can break if you spray directly at them.

- Don't spray under the laps of horizontal siding; it can lift them. And don't spray directly into crawl spaces or gable-end vents.

- Don't let children operate a power washer.

- When it's operating, never put your hand near the tip of the wand or aim it at a person or animal. The water will penetrate and cause severe injury.

- Keep at least 10 feet from any power lines.

You'll be working with a lot of water pressure but with a little practice you should be able to control the wand. Keep in mind that a telescoping wand - which you'll need to reach higher floors - can kick back 3 to 4 feet each time you depress the handle.

You will probably tire from fighting the water pressure. When you do, take a break.

Is there any way of stablilizing a tree with a crack running up it's trunk?




Count DiMe


It is a large tree and I do not want to resort to cutting it down, any suggestions would be appreciated


Answer
I remember a maple tree across the street from us that was split right down the middle from lightening. My neighbor did not want to lose the tree, so many of us neighbors gathered together what we could to help save the tree:
We got the longest bolt, washers & nut we could find, some chain, & straps & got to work.

With the straps, winch together the tree as tight as you can get it.
Drill a hole right thru the middle of the tree & install the very long bolt with a wide washer through it. Attach a washer & nut on the other side. Wrap the tree very tight with the chain just above the bolted area to keep the pressure off the bolt. Remove the strap, but leave the chain. The tree will heal around the bolt, around the chain & mend the crack.

If the crack is due to an injury, it will absorb the hardware within itself.
If the tree is split due to disease, be sure to treat the sick tree, then perform the surgery after.

That maple tree lived for 30 plus years after it was bolted & chained back together. You couldn't even tell where the chain or bolt was!




Powered by Yahoo! Answers

Tidak ada komentar:

Posting Komentar