If I connect 2 pressure washer pumps to a motor, will I get double the output????? help?

pressure washer no water flow image

wehaulmove

ok here is the situation, I have two 3000PSI pressure washer pumps, and a gas engine, If I took both and connected them to the motor, supplied enough water flow and used a coupler to join the output on both, will I get 6000psi of water pressure or will I end up creating back pressure and possibly damaging the pums, or will I get killed in the process.

I hope someone with an engeniering degree reads this, maybe I can get a valid answer. oh and forgive me for my spelling disaster here....he he he

Answer
If you have enough power in your gas engine to run both pumps, you may get almost twice the volume output of one pump at 3000PSI. For your next question, try the 'Check Spelling' feature located above the box.

How can i tell what pressure my pressure washer is at?

N/A

I have a 3800 psi dewalt pressure washer and im wanting to turn it down to about 3000-3300 psi but im not sure to tell what psi im at while turning the pressure down.
If anyone could help me out id appreciate it!
Thanks!

Answer
What you would have to do is connect a pressure gauge between the end of the hose and the gun. Run the pressure washer with the gun's trigger pressed so there's water flow and check the pressure it is shooting water. To adjust it to the pressure you want you can either use the unloader to regulate pressure or adjust the engine's rotation which would also regulate pressure.
If you need a gauge here is the link to a 5000 psi one. There are more on the website in case you think this one is too much.
http://www.roncoshop.com/GAUGE_KIT_5000_PSI_85305001_p/85305001.htm

Powered by Yahoo! Answers