Minggu, 09 Maret 2014

Pressure washer problems?




Christophe


I have a 2 year old craftsman 3000 PSI, 2.7 GPM w/ a Briggs & Stratton engine pressure washer, (Model 580.752270). It starts and runs great but then turns off about 30 seconds later. I have changed the gas, and the oil level is fine. I have noticed that when I press the prime button it sounds like it just priming with air. I also have checked the small red plastic fuel filter and it's good. Please help!!!
Leaving the gas cap off worked, now how do I fox it?



Answer
Try running it without the gas capon.
The vent in it might be plugged up and not allowing air in, as the gas goes out creating a vacuum in the tank.

Is it legal to use pressure washer to clean car?




Tom


Hi, I would like to know if its legal to use pressure washer to clean car on a public road ?


Answer
Pressure washing contractors do it every day, the legal issue has to do with reclaiming the water. Some cities are mandating that if you wash a car with a pressure washer, you must have a system to vacuum the water back up. They state that cars get many contaminants that should not be washed down the drain. Some cities will require you to pick the water up, AND have a special permit to do so. Check my sources- I have included a forum discussion on this among pressure washer contractors, and a document from the New Hampshire Department of Environmental Services. Check with your county, city, and state for the mandates to make sure you are not breaking any laws.




Powered by Yahoo! Answers

Tidak ada komentar:

Posting Komentar