Brad25
The washer will not run when the water is hook up. If i disconnect the water than it will startup just fine. You can feel the binding when the water is on and hooked up when you pull start it. So given that the pump is bad. What is bad on the pump? Is the repair kits a good idea or just buying the new universals pump for 100 bucks? Any advice or experience would be appreicated.
Answer
when the water is connected to the washer try pulling the trigger on the gun without the washer turned on if water comes out keep the trigger held for a few moments to prime the washer then try turning it back on. if no water comes out of it at all even when turned off then it sounds like there is a blockage some where check if there are any filters in the pressure washer they are usually behind where u plug the hose pipe into. try screwing it off and giving it a rinse.
Also pressure washers should never be used without water connected to them as this can damage the compressor pump very easily
when the water is connected to the washer try pulling the trigger on the gun without the washer turned on if water comes out keep the trigger held for a few moments to prime the washer then try turning it back on. if no water comes out of it at all even when turned off then it sounds like there is a blockage some where check if there are any filters in the pressure washer they are usually behind where u plug the hose pipe into. try screwing it off and giving it a rinse.
Also pressure washers should never be used without water connected to them as this can damage the compressor pump very easily
Will a 1750PSI attachment fit in an 1800PSI Pressure Washer?
heheman140
I just purchased used 1800 PSI pressure washer but I did not come with a variable lance, or a turbo lance. After doing some research I found a kit (in my price) which includes both the attachments and also comes with a new gun and a hose. But the only problem is that the max pressure is 1750 PSI for this kit. I was wondering if this kit will work with my 1800PSI pressure washer. I have attached a link below for the website.
http://www.pwmall.com/website/Nproductdetail.aspx?ITEMNMBR=OAK-KIT-2&BCATCHILDID2=1&ID=123464
Also if anyone knows any websites where I would be able to purchase similar attachments for the pressure washer, please post it.
Thanks
Thanks a lot fred k. Yes i am looking for a US supplier.
Answer
There is not a problem with the small pressure difference.
Pressure washers are advertised with a Maxiumum pressure rating but that only really applies to the best possible operating conditions.
As soon as the jet leaves the lance, the effective pressure is reduced. At the tip the pressure is enough to cut through soft materials but 5m away you will just get wet.
The only proviso is making sure the accessories fit the gun, but as you have chosen a complete kit there should not be any problem.
As the link is in $US, do you want a US supplier?
There is not a problem with the small pressure difference.
Pressure washers are advertised with a Maxiumum pressure rating but that only really applies to the best possible operating conditions.
As soon as the jet leaves the lance, the effective pressure is reduced. At the tip the pressure is enough to cut through soft materials but 5m away you will just get wet.
The only proviso is making sure the accessories fit the gun, but as you have chosen a complete kit there should not be any problem.
As the link is in $US, do you want a US supplier?
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar