pressure washer cat pump image
Sawkeen
I've got water in the oil in my Cat pump crank case. Can I rebuild or is it cheaper to buy new? Where can I order cheapest parts?
Answer
well like cat says they have nine lives lol. you can just run it to churn it up and then drain it out. fill with new oil and run it again until warm and drain again. fill once more and you should be fine i think. cat pumps are pretty tough i hear.
well like cat says they have nine lives lol. you can just run it to churn it up and then drain it out. fill with new oil and run it again until warm and drain again. fill once more and you should be fine i think. cat pumps are pretty tough i hear.
How to remove CAT water pump from Ridgid Motor?
Leonel
I have a pressure washer that is Ridgid 3300 psi and i am replacing the motor but i do not know how to remove the water pump and i was wondering if there is any one that knows how to and if they can tell me how they did it and what tools to use. thank you for any more information please email me
estr5160@gmail.com
Answer
It's really just removing the mounting bolts on the pump and pulling it free of the engine. There should be some set screws in the drive shaft you will have to loosen. if you don't see these, find a hole in the drive shaft cover and pull the starter cord a little at a time to rotate the shaft, These holes are there to access the set screws. If you are still having a hard time, you may have to gently break the drive shaft free, check my source on this process.
It's really just removing the mounting bolts on the pump and pulling it free of the engine. There should be some set screws in the drive shaft you will have to loosen. if you don't see these, find a hole in the drive shaft cover and pull the starter cord a little at a time to rotate the shaft, These holes are there to access the set screws. If you are still having a hard time, you may have to gently break the drive shaft free, check my source on this process.
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar