Brett
Trying to start this pressure washer (water hose was hooked up and everything), got it to start and it ran for about 10 seconds before it just stopped, sounded like the line was pushing water and getting stuck somewhere cause when I went to restart it the pull start was hard as a rock and when I finally pulled it something blew and water was coming out the bottom around the outlet tube, I had everything hooked up right I just wanna know if there is something else that would cause this
oh actually no water at all was coming out the end of the wand even if I pressed the trigger down
Answer
This is typically caused by a build up of pressure in the pump. Depending
on the pump on the washer, that build can be caused by a bad unloader or
even a stuck check valve. Please do not run the unit without the water
running, doing this can cause the internal parts of the pump to overheat
and possible become damaged. I would recommend contacting the manufacturer
of the pressure washer for a parts break down on the pump. Typically the
unloader and the check valves are simple to replace.
This is typically caused by a build up of pressure in the pump. Depending
on the pump on the washer, that build can be caused by a bad unloader or
even a stuck check valve. Please do not run the unit without the water
running, doing this can cause the internal parts of the pump to overheat
and possible become damaged. I would recommend contacting the manufacturer
of the pressure washer for a parts break down on the pump. Typically the
unloader and the check valves are simple to replace.
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar